22116 Autoloader 2 ALE2: Measured Main Scan Size (%d.%d\") larger than maximum allowable size ThermoFlex If the machine is refusing to accept the correct size plates, check on the configuration (50x67 vs 52x80) via the following paramters: sys maxssz - Password protected encoded value for the subscan size of the machine config msz - Should be set to value to match the customers machine type (ie. 50 or 52) config ssz - Same as msz but for ThermoFlex acceptable values are 67 or 80 Re-submit with an acceptable sized plate. If plate dimensions are already within the maximums for your ThermoFlex then contact Creo Service. The plate loaded is larger than the largest plate acceptable on the machine. ../nvs/sys_cfg_maxssz.xmlNVS: sys maxssz ../nvs/config_cfg_msz.xmlNVS: config msz ../nvs/config_cfg_ssz.xmlNVS: config ssz ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:56 2008 PST